RESEARCH OF MAGNETIC FIELD DISTRIBUTION IN THE WORKING AREA OF DISK SEPARATOR, TAKING INTO ACCOUNT AN INFLUENCE OF MATERIALS OF PERMANENT MAGNETS
Abstract
Based on the results of a numerical-field analysis of the distribution of the magnetic force field in the working area of the disk magnetic separator, designed to clean bulk substances from ferromagnetic inclusions, the influence of the magnetic material of the poles of the magnetic system on the field distribution is determined. A consistent study of two magnetic systems assembled on the basis of magnetic materials of different classes is carried out. The finite element method implemented in the COMSOL Multiphysics software environment is used to calculate the distribution of magnetic induction in a disk magnetic separator with rare-earth and ferrite magnets. Due to the complexity of the spatial geometry of the force field in the working area of the disk magnetic separator, a three-dimensional model of the magnetic system is developed. A comparative analysis of the distribution of the magnetic force field in the working area of the disk separator with a highly coercive magnetic system and with a magnetic system based on ferrite blocks is carried out. As a result of the analysis, it is found that the indicators of the intensity and heterogeneity of the magnetic field for a highly coercive magnetic system significantly exceed the corresponding parameters of a ferrite magnetic system. It is proved that when choosing magnets for the magnetic system of a disk separator, preference should be given to highly coercive alloys, the magnetic properties of which significantly exceed the magnetic properties of ferrite magnets. To reduce the cost of the magnetic system of the disk separator, the use of a combined magnetic system assembled from magnetic materials of different classes is proposed. Studies of combined magnetic systems with various mass fractions of magnetic materials are done. The ratio of the mass fractions of magnets of various properties in the poles of the magnetic system is determined, at which sufficiently high magnetic characteristics are provided in the working area. It is shown that the presence of a ferrite fraction in the magnetic poles not only reduces the cost of the magnetic system of the separator, but also reduces the mass of the system. The tasks of further research are justified
Downloads
References
Li, Y., Yang, F. (2016). Research Progress and Development Trend of Permanent Magnetic Separators in China and Abroad. DEStech Transactions on Engineering and Technology Research. doi: https://doi.org/10.12783/dtetr/icvme2016/4873
Slusarek, B., Zakrzewski, K. (2012). Magnetic properties of permanent magnets for magnetic sensors working in wide range of temperature. Przeglad elektrotechniczny, 88 (7), 123–126.
Dimova, T., Aprahamian, B., Marinova, M. (2019). Research of the Magnetic Field Inside a Drum Separator With Permanent Magnets. 2019 16th Conference on Electrical Machines, Drives and Power Systems (ELMA). doi: https://doi.org/10.1109/elma.2019.8771679
Hisayoshi, K., Uyeda, C., Terada, K. (2016). Magnetic separation of general solid particles realised by a permanent magnet. Scientific Reports, 6 (1). doi: https://doi.org/10.1038/srep38431
Meshcheryakov, I. (2018). Spetsifika vybora magnitnyh materialov dlya magnitnyh separatorov. Kombikorma, 2, 22–24.
Sayko, O. P., Drobchenko, V. I., Kofanov, A. S., Podolyuh, S. M. (2012). Shkivnye zhelezootdeliteli na postoyannyh magnitah. Ugol' Ukrainy, 7, 43–45.
Romanyshyn, T. L. (2013). Obgruntuvannia vyboru materialu postiynykh mahnitiv dlia lovylnykh prystroiv. Rozvidka ta rozrobka naftovykh i hazovykh rodovyshch, 1 (46), 143–152.
Lungu, M. (2009). Separation of small nonferrous particles using a two successive steps eddy-current separator with permanent magnets. International Journal of Mineral Processing, 93 (2), 172–178. doi: https://doi.org/10.1016/j.minpro.2009.07.012
Zeng, S., Zeng, W., Ren, L., An, D., Li, H. (2015). Development of a high gradient permanent magnetic separator (HGPMS). Minerals Engineering, 71, 21–26. doi: https://doi.org/10.1016/j.mineng.2014.10.009
Gómez-Pastora, J., Xue, X., Karampelas, I. H., Bringas, E., Furlani, E. P., Ortiz, I. (2017). Analysis of separators for magnetic beads recovery: From large systems to multifunctional microdevices. Separation and Purification Technology, 172, 16–31. doi: https://doi.org/10.1016/j.seppur.2016.07.050
Karlov, A., Kondratenko, I., Kryshchuk, R., Rashchepkin, A. (2014). Magnetic system with permanent magnets for localization magnetic nanoparticles in a given region of the biological environments. Elektromekhanichni i enerhozberihaiuchi systemy, 4, 79−85.
Chen, H., Bockenfeld, D., Rempfer, D., Kaminski, M. D., Liu, X., Rosengart, A. J. (2008). Preliminary 3-D analysis of a high gradient magnetic separator for biomedical applications. Journal of Magnetism and Magnetic Materials, 320 (3-4), 279–284. doi: https://doi.org/10.1016/j.jmmm.2007.06.001
Myazin, V., Kilin, V., Yakubaylik, E. (2010). Perfection of methods and technology of highly magnetic iron ore concentration in connection with the innovations of the last years (by the example of the Siberian region). Vestnik ChitGU, 6 (63), 95–101.
Kravchenko, A. Y., Bovda, A. M. (2003). Combined permanent magnets: expansion of permanent magnets classification. Elektrotekhnika i Elektromekhanika, 3, 37–39.
Gerlici, J., Shvedchikova, I. A., Nikitchenko, I. V., Romanchenko, J. A. (2017). Investigation of influence of separator magnetic system configuration with permanent magnets on magnetic field distribution in working area. Electrical Electrical Engineering & Electromechanics, 2, 13–17. doi: https://doi.org/10.20998/2074-272x.2017.2.02
Copyright (c) 2019 Iryna Shvedchykova, Inna Melkonova, Julia Romanchenko

This work is licensed under a Creative Commons Attribution 4.0 International License.
Our journal abides by the Creative Commons CC BY copyright rights and permissions for open access journals.
Authors, who are published in this journal, agree to the following conditions:
1. The authors reserve the right to authorship of the work and pass the first publication right of this work to the journal under the terms of a Creative Commons CC BY, which allows others to freely distribute the published research with the obligatory reference to the authors of the original work and the first publication of the work in this journal.
2. The authors have the right to conclude separate supplement agreements that relate to non-exclusive work distribution in the form in which it has been published by the journal (for example, to upload the work to the online storage of the journal or publish it as part of a monograph), provided that the reference to the first publication of the work in this journal is included.