TY - JOUR AU - Trung, Do Duc AU - Nguyen, Nhu-Tung AU - Van Duc, Duong PY - 2021/03/29 Y2 - 2024/03/29 TI - STUDY ON MULTI-OBJECTIVE OPTIMIZATION OF THE TURNING PROCESS OF EN 10503 STEEL BY COMBINATION OF TAGUCHI METHOD AND MOORA TECHNIQUE JF - EUREKA: Physics and Engineering JA - Eureka: PE VL - IS - 2 SE - Engineering DO - 10.21303/2461-4262.2020.001414 UR - https://journal.eu-jr.eu/engineering/article/view/1699 SP - 52-65 AB - In this study, the multi-objective optimization problem of turning process was successfully solved by a Taguchi combination method and MOORA techniques. In external turning process of EN 10503 steel, surface grinding process, the orthogonal Taguchi L9 matrix was selected to design the experimental matrix with four input parameters namely insert nose radius, cutting velocity, feed rate, and depth of cut. The parameters that were chosen as the evaluation criteria of the machining process were the surface roughness (Ra), the cutting force amplitudes in X, Y, Z directions, and the material removal rate (MRR). Using Taguchi method and MOORA technique, the optimized results of the cutting parameters were determined to obtain the minimum values of surface roughness and cutting force amplitudes in X, Y, Z directions, and maximum value of MRR. These optimal values of insert nose radius, cutting velocity, feed rate, and cutting depth were 1.2 mm, 76.82 m/min, 0.194 mm/rev, and 0.15 mm, respectively. Corresponding to these optimal values of the input parameters, the surface roughness, cutting force amplitudes in X, Y, Z directions, and material removal rate were 0.675 µm, 124.969 N, 40.545 N, 164.206 N, and 38.130 mm3/s, respectively. The proposed method in this study can be applied to improve the quality and effectiveness of turning processes by improving the surface quality, reducing the cutting force amplitudes, and increasing the material removal rate. Finally, the research direction was also proposed in this study ER -